Boss BV9562B Operator's Manual download pdf (Page 19)

OPERATOR’S MANUAL FOR LS SERIES

Working with Microsoft Windows

Windows XP

LaserCut 5.3 works well with Windows XP. Install the LaserCut software, plug in dongle,

and plug laser USB cord into an available and all the drivers should automatically

install. LaserCut should now communicate directly with the laser machine.

Windows 7

LaserCut 5.3 will work with Windows 7, but requires two additional steps for a

successful installation.

Step 1

Windows 7 does not like unsigned device drivers, blocking their installation and

keeping your computer from communicating with the laser machine. To get around

this you must temporarily disable the signature verification process.

• Go to the Start Menu / Run and type in the following command

• Bcdedit / set nointegritychecks on

• Restart the PC and install the unsigned drivers by installing LaserCut and

attaching the laser USB cord into a empty USB port

• Go to the Start Menu / Run and type in the following command

• Bcdedit / set nointegritychecks off

Step 2

LaserCut needs to run in the XP mode of windows 7.

• Right click the LaserCut icon on your windows 7 desktop

• Slide down and highlight the properties menu item

• Click on the Compatibility tab

• Check the [Run this program in compatibility mode for] box

• Click the drop down box arrow to show Windows XP (Service Pack 3) choice.

Click the OK button.

These two steps should allow you software/laser machine to communicate and work

perfectly with Windows 7.

BOSSLASER - Page | 17

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 30 31

No comments

Boss BV9562B Operator's Manual Page 19