Boss BV9562B Operator's Manual download pdf (Page 20)

OPERATOR’S MANUAL FOR LS SERIES

Windows 8

LaserCut needs to run in the XP mode of windows 8.

• Right click the LaserCut icon on your windows 8 desktop

• Slide down and highlight the properties menu item

• Click on the Compatibility tab

• Check the [Run this program in compatibility mode for] box

• Click the drop down box arrow to show Windows XP (Service Pack 3) choice.

Click the OK button.

Now update the EZUSB Hub driver

• Using the mouse move cursor over to the upper right corner until the Settings

icon appears, select Settings

• Select the Control Panel Icon

• Select System and Security

• Under System, select Device Manager

• Under Universal Serial Bus Controllers look for the LT Slave USB Driver or the

EZUSB Hub driver.

• Click on the driver, right click and update. If you’re hooked up to the internet

select, Update over internet, otherwise select find on local disk and make sure

the CD is in the drive.

This should solve any issues with Windows 8.

BOSSLASER - Page | 18

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 30 31

No comments

Boss BV9562B Operator's Manual Page 20