Boss BV9562B Operator's Manual download pdf (Page 29)

OPERATOR’S MANUAL FOR LS SERIES

You have a few options:

1) Use an aquarium heater to warm the water. Set the temperature to a moderate

level. The water in the hoses could still freeze. Use a simple timer switch to turn the

water pump on/off every fifteen minutes.

2) If you are worried about wasting the life of your water pump, then drain the laser

coolant from the entire system. Disconnect the hoses from the laser machine. Use an

air compressor to blow out as much water as you can (Blow air into the hose that water

comes out of the laser machine. This should clear out the most water). Take the chiller

to somewhere that will not freeze. Put a heater inside the laser machine.

3) Move the laser machine system to somewhere warm.

Use a dehumidifier:

Humidity can cause the metal parts of the laser machine to rust. All metal is expected

to rust. One unexpected metal surface is the laser mirrors. It is best to try to control the

humidity level in the laser work area. Clean the mirrors and check for this oxidation as

a possible problem. Replace mirrors that do not meet your expectation of

performance.

Make a maintenance schedule:

The easiest way to follow a cleaning schedule is to buy a calendar and write on the

dates that you want to do the maintenance. Some maintenance is needed on a regular

basis while other cleaning could be an immediate requirement after a disaster. Just

know that avoiding the maintenance of your laser could result such that the laser

doesn't work right ...or doesn't work at all.

BOSSLASER - Page | 27

1 2 ... 24 25 26 27 28 29 30 31

No comments

Boss BV9562B Operator's Manual Page 29