Boss BV9562B Operator's Manual download pdf (Page 18)

OPERATOR’S MANUAL FOR LS SERIES

Moving files (your drawings) to the laser

With the

Hello World

file still loaded on LaserCut press the DOWNLOAD button in lower right

corner as illustrated in the picture below. The file manager pops up. Click on the DOWNLOAD

CURRENT button shown below.

The file should now be in the laser machine memory and showing up on the LCD screen. You

may have to select the file from the list of stored jobs in the machines memory. To keep

operations simple it’s a good idea to Click the DEL ALL button before the DOWNLOAD

CURRENT button to clean out the machines memory.

Once the file HELLOWORLD shows up on the LCD display press the DATUM button as shown

in the picture above, then press RUN BOX. Run Box will move the laser head to simulate

where the work will be done. Make sure your scrap piece of wood is in the simulated area.

Now uncheck the IMMEDIATE radio button on the software as shown checked above and

if your laser is ready to go, press START. Hello World should be engraved on your scrap wood

in just a few seconds.

Now go back and do it again, playing with different power and speed settings. Power is a %

of total power and speed is mm per minute.

BOSSLASER - Page | 16

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 30 31

No comments

Boss BV9562B Operator's Manual Page 18