Boss Food Processor Service Manual download pdf (Page 10)

MOTOR STARTING CAPACITOR REPLACEMENT

4. Disconnect the blue wire/connector from the top/RH

terminal on the

motor starting capacitor going to the

top/LH side of the adapter that is plugged into the relay

switch.

- 7 CUP FOOD PROCESSORS -

To replace the motor starting capacitor for the 7 cup food

processor:

5. Remove the

motor starting capacitor from its nest in the

motor housing.

NOTE: The following replacement procedure is

described with the motor housing turned

on its side on a cushioned surface and the

motor starting capacitor oriented down.

NOTE: If needed for the new capacitor, retain the

rubber motor pad attached to the side of

the old motor starting capacitor.

1. Unplug the power cord and remove the housing base.

2. Disconnect the red wire/connector from the top/LH

terminal on the

motor starting capacitor going to the

motor. The other terminal on the LH side will not have any

connection.

6. Apply the rubber motor pad in approximately the same

position as it was on the old capacitor.

7. Insert the new

motor starting capacitor (in approximately

the same orientation as the old capacitor) into its nest

making sure it is fully seated and the rubber motor pad is

in contact with the motor.

3. Disconnect the blue wire/connector from the bottom/RH

terminal on the

motor starting capacitor going to the

safety switch. The safety switch is attached at the

inside/top of the motor housing.

8. Plug the one (1) red and two (2) blue wires onto the same

terminals on the

motor starting capacitor as they were

removed.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 49 50

No comments

Boss Food Processor Service Manual Page 10