Boss Food Processor Service Manual download pdf (Page 13)

SWITCH ASSEMBLY & NEON LAMP

6. Using a T10 torx driver, remove the two (2) M3X15 screws

securing the switch assembly to the motor housing/switch

panel overlay.

REPLACEMENT

- 7 CUP FOOD PROCESSORS -

7. Remove the switch assembly from the motor housing and

switch panel overlay.

To replace the switch assembly and neon lamp on the 7 cup

food processor:

8. Manipulate the relay switch/mounting tab out of its rubber

mounting block (attached to the switch assembly) for use

on the new switch assembly.

NOTE: The following replacement procedure is

described with the motor housing turned

on its side on a cushioned surface and the

switch assembly oriented down.

NOTE: The red neon lamp lens is slip-fit into the

switch assembly. Remove and save it for

the new switch assembly.

NOTE: Cable ties may have to be removed to

perform this procedure.

9. To remove the neon lamp, loosen the screw in the switch

assembly terminal block securing the brown 22 gauge wire

going to the neon lamp. Remove and separate the wires.

1. Unplug the power cord and remove the housing base.

2. Perform steps 1 and 2 of the relay switch replacement

procedure. If needed, pull the relay switch out of its rubber

mounting block.

NOTE: The brown neon lamp wire and the red

wire going to the NO terminal on the

switch assembly are twisted together

when inserted into the switch assembly

terminal block. Separate the two wires to

remove the neon lamp.

3. Loosen the screw on the power cord terminal block

securing the white wire going to the motor and the white 22

gauge wire going to the neon lamp. Remove the neon

lamp wire and retighten the terminal block screw to secure

the white motor wire.

4. Loosen the screw on the power cord terminal block

securing the black wire going to the common terminal

(marked COM1) on the switch assembly. Remove the

black wire from the power cord terminal block.

10. Replace the red neon lamp lens into the new switch

assembly by aligning the tab on the lens with the slot in the

switch assembly. Make sure the lens is fully seated

against the switch assembly.

5. Loosen the screw on the switch assembly terminal block

securing the brown wire going to the safety switch NO

terminal. Remove the brown wire from the switch

assembly terminal block.

11. Install the switch assembly by manipulating it into position

over the bosses on the switch panel overlay.

12. Insert the two (2) M3X15 screws and tighten using a T10

torx driver.

13. Connect the wires in the reverse order.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 49 50

Comments to this Manuals

No comments

Boss Food Processor Service Manual Page 13

Comments to this Manuals

Related products and manuals for Food processors Boss Food Processor