Boss Food Processor Service Manual download pdf (Page 20)

SPLASH PROOF SWITCH LEVER/TORSION

6. With the bottom of the motor housing facing up and the

switch assembly face orientated towards the top, insert the

torsion spring over the lever mounting boss with the “L-

shaped end towards the right and facing up. Make sure

the straight end of the spring is located between the safety

switch mounting boss and the motor housing. Make sure

the spring is fully seated at the bottom of the lever

mounting boss.

SPRING REPLACEMENT

7 CUP FOOD PROCESSORS -

To replace the splash proof switch lever/torsion spring for the 7

cup food processor:

1. Unplug the power cord and remove the housing base.

7. Using a small screw driver, apply enough tension to the L-

shaped end of the spring to allow the switch lever to be

mounted over the lever mounting boss. The L-shaped end

of the spring must seat into the v-profile on the back side

of the switch lever. Make sure the switch lever and the

torsion spring are properly located and seated in the motor

housing.

2. Perform steps 1 – 5 of the SAFETY SWITCH

REPLACEMENT procedure.

3. Rotate the switch lever towards the inside of the motor

housing until the striker post is clear of the motor housing.

4. Carefully pull up on the lever and remove it from the lever

mounting boss on the motor housing. Make sure not to

damage the torsion spring if it is to be reused.

5. If damaged, remove the torsion spring by pulling it off the

lever mounting boss.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 49 50

No comments

Boss Food Processor Service Manual Page 20