Boss DN-2 Owner's Manual

Owner’s ManualDCACAC & BATTERYPOWEREDFETDN-2_e1.fm 1 ページ ２００６年１２月８日　金曜日　午後１時４４分

10 Operating the Unit fig.06 4. Adjust the tone with the TONE knob. fig.07 5. Adjust the output volume with the LEVEL knob.Normally, you should adjus

11 Changing the Battery When the indicator goes dim or no longer lights while the effect is on, it means that the battery is nearly dead and must be

12 Troubleshooting The power won’t come on / the CHECK indicator doesn’t light ● Is the specified adaptor (PSA-series, sold separately) properly conn

13 Setting Samples DN-2 Overdrive fig.09-01 Crunch fig.09-02 Long Sustain for Solo fig.09-03 Chord Play fig.09-04DRIVEDRIVEDRIVEDRIVEDN-2_e1.fm 13 ペー

14 Setting Memo fig.10 fig.10 fig.10 fig.10DRIVEDRIVEDRIVEDRIVEDN-2_e1.fm 14 ページ ２００６年１２月８日　金曜日　午後１時４４分

15 Specifications DN-2: Dyna Drive Nominal Input Level... -20 dBuInput Impedance... 1 M Ω Nominal Ou

16 Specifications Dimensions... 73 (W) x 129 (D) x 59 (H) mm 2-7/8 (W) x 5-1/8 (D) x 2-3/8 (H) inchesWeight ...

17 MEMODN-2_e1.fm 17 ページ ２００６年１２月８日　金曜日　午後１時４４分

18 MEMODN-2_e1.fm 18 ページ ２００６年１２月８日　金曜日　午後１時４４分

This product complies with the requirements of European Directive 89/336/EEC.For EU CountriesFor CanadaThis Class B digital apparatus meets all requ

2 Thank you, and congratulations on your choice of the BOSS DN-2 Dyna Drive.Before using this unit, carefully read the sections entitled: “USING THE

G6027117R0DN-2_e1.fm 20 ページ ２００６年１２月８日　金曜日　午後１時４４分

3 Main Features ● The DN-2 is an overdrive that changes the tone in response to the force of picking and the volume control on the guitar. ● Transfor

4 Panel Descriptions fig.01 1. AC Adaptor Jack This jack accepts the connection of an AC adaptor (optionally available BOSS PSA-se-ries). By using an

5 Panel Descriptions line voltage be interrupted due to a power blackout or power cord disconnection. 2. CHECK Indicator This indicator shows whethe

6 Panel Descriptions 6. INPUT Jack This jack accepts signals coming from a gui-tar or other musical instrument, or another effects unit. * The INPUT

7 Connections * Inserting a connecting plug into the INPUT jack turns on the power to the unit.* Raise the amp volume only after turning on the power

8 Connections fig.03 * This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit w

9 Operating the Unit fig.04 1. After you have made the necessary con-nections (p. 7, 8), set the panel knobs as shown in the illustration. fig.05 2.