Boss DN-2 Owner's Manual download pdf (Page 11)

Changing the Battery

When the indicator goes dim or no longer

lights while the effect is on, it means that the

battery is nearly dead and must be replaced.

Replace the battery following the steps below.

* The use of an AC adaptor is recommended as the

unit’s power consumption is relatively high. Should

you prefer to use a battery, please use the alkaline type.

fig.08

Loosen the thumbscrew at the front of

the pedal, and then lift the pedal

upwards to open the unit.

* The thumbscrew can be left in the pedal while

changing the battery.

Remove the old battery from the battery

housing, and remove the snap cord con-

nected to it.

Connect the snap cord to the new battery,

and place the battery inside the battery

housing.

* Be sure to carefully observe the battery’s polarity (+

versus -).

Slip the coil spring onto the spring base

on the back of the pedal, and then close

the pedal.

* Carefully avoid getting the snap cord caught in the

pedal, coil spring, and battery housing.

Finally, insert the thumbscrew into the

guide bush hole and fasten it securely.

Thumbscrew

Pedal

Spring Base

Coil Spring

Guide Bush

Hole

Battery Housing

Battery Snap

Cord

Battery

Snap

9V Battery

DN-2_e1.fm 11 ページ２００６年１２月８日　金曜日　午後１時４４分

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

No comments

Boss DN-2 Owner's Manual Page 11